Contact person:

Frank Richter

(Head of department)
Tel +49 40 540093-76
Fax +49 40 540093-47

Melissa Seelig

Tel +49 40 540093-13
Fax +49 40 540093-47

Moulded parts

WILLBRANDT Profiles and Moulded Part (English) - P40101


Request catalogue

Moulded parts are produced in one pressing operation. Whether a simple press mould, injection mould or injection-moulding process is used depends on the piece number, quality, economy and geometry of the article. By means of subsequent vulcanisation, the rubber is converted from a plastic to an elastic state under the influence of temperature, pressure and time.

The following list contains only a small selection of the elastomer products we produce using the press, injection or injection-moulding process:

  • Rubber moulded parts (e.g. made of silicone, EPDM, etc.)
  • Rubber-metal and rubber-fabric joints
  • Plastic injection moulded parts
  • Bellows and sleeves
  • Buffers
  • Elbows
  • Cable glands
  • Handles
  • Stamped and milled parts made of rubber and plastic
  • and much more
printPrivacy PolicyImprint